How can I in a rod holder with a fiberglass boat

Posted on

How can I in a rod holder with a fiberglass boat . Hi all of fishing lovers, Today’s post is “How can I in a rod holder with a fiberglass boat “. We hope this short article is useful for you, all fishing lovers.

How can I in a rod holder with a fiberglass boat

 The place in a rod holder using a fiberglass boat

Install raise a number of built-in rod holders for your boat to your chances of catching game perch. Even if you have a fiberglass motorboat, your choices do not usually limited to just clamp rod. slots installing to mount an even rod holder is actually a fairly simple process, all you need is a few tools and many safety features installed flush fishing rod holder entails drilling gunwale of the boat, which will allow you to fish with simplicity, while also maintaining. much more organized your boat.

Instructions

    1

    Choose a location on the side deck and use the marker to mark the best places a hole to drill your fishing rod holder. Operate measuring tape on the side deck to check the center. Make sure the place is completely free of obstacles in the gangway.

    2

    Place masking tape around the area to protect the gel coating from damage.

    3

    Put in your dust mask and even goggles to run fiber optic installation.

    4

    saw a drill hole aided by the 2. 5-inch hole for the area marked every preconceived.

    5

    Smooth the edges to excess fiber while using the hand file.

    6

    Test match rod holder flush in your hole and mark the spot that needs to be drilled holes in the flange.

    7

    Drill holes across the surface by following your propeller brands that you just created. This is the place that the flange gasket or of the rod holder is likely to be attached. The screw size would be determined by the elected eliminate mount rod display rack.

    8

    Put silicone in just about every screw hole, insert the rod holder in the direction of the gunwale hole. Screw the flange directly in place and harden to make the rod holder assembly using the key.


Article source: fishingstory74.blogspot.com

May You Also Like

Leave a Reply

Your email address will not be published. Required fields are marked *