How do you get a Crab Pot Puller . Hi all fishing lovers, Today’s post is “How do you get a Crab Pot Puller “. i hope that this article is helpful for you, all fishing lovers.
How do you get a Crab Pot Puller
Crab is often a sweet fish delicacy enjoyed in many preparations, most once fried crab cakes. these prehistoric looking creatures have salt waters around the world, as Chesapeake and S. f. Bays on the American shores. Traditional , fishermen catch any crustaceans by means of bait placed in a grid, also known as a “pot. “Crabbers drag the thing here we are at the surface by wrapping a rope that is among the top pot. While benefiting commercial fishing of motorized devices, an amateur can be a crank to serve as generate the crab pot puller .
Make every flagpole stand on the deck of your boat, so the tube can be pure if inserted.
Screw about 90 degrees elbow in a threaded end of the 10-foot galvanized line and tighten with a pipe wrench. the end of the tube devoid of the elbow should fit snugly inside the flagpole base when the construction can properly be rounded up to the crab pot puller.
Attach a type of 90 degree elbow, a 18-inch post of galvanized pipe, including a T-piece in the correct order. the tee openings will be in parallel with the elbow to the top.
Screw the 3-foot-long threaded galvanized pipe in each of the open elbow ends on the 18-inch and 10-foot piping.
Place the actual 10-foot vertical pipe inside flagpole stand.
Drill a hole through the 10-foot pipe, about 5 feet into the deck of the particular boat. The hole may be perpendicular to the direction of your 3-ext foot pipe, and openings in the tee.
Close and lock all handle rope pulley to stick with a 4-inch carriage bolt next nut. Loosely turn the pulley so that it preserves the freedom of movement.
Get a crab pot line in the water plus feed during the tee toward your long vertical pipe. Attach the rope pulley and start turning to manage to reel from the pot.
Article source: fishingstory74.blogspot.com