How in Eagle Muskie Finder Transducer

Posted on

How in Eagle Muskie Finder Transducer . Hi all of fishing lovers, Today’s post is “How in Eagle Muskie Finder Transducer “. i hope that this article is useful for you, all fishing lovers.

How in Eagle Muskie Finder Transducer

 how an Eagle Striped Bass Transducer Finder Run

fish finders use sonar to get the location of muskie and determine the depth of the water that you are fishing in general. A transducer sends and receives surf sonar. If the transducer records the sonar ocean, the information centers in the view of some fish finder. Disruption of air turbulence causes can possibly cause transducer readings. installing the transducer on the site free of turbulence will always receive the correct H2O depth and muskie locations.

Instructions

    1

    Launch your boat inside of a body of mineral water.

    2

    Please enter a reduced portion of the fuselage using two inches on water.

    3

    Drive you to accelerate own boat while an assistant holds the transducer and under water against the hull. Look at the image displayed for the fishfinder. Have your helper move the transducer prior to each display clean image without the need for static or brands.

    4

    Mark the position of the transducer, which has a wax crayon.

    5

    Switch from the boat bilge pump the water through the hull.

    6

    Mount all transducer. Wipe the highlighted part of the fuselage with the dry cloth. Sand the designated area with a 80-grit sandpaper that the hull is never smooth. Mix gradually set epoxy. Serve the epoxy at the marked space. Allow to release the air bubbles from your epoxy. Press the transducer into your epoxy. Push the transducer in the hull. Allow the epoxy to cure for 24 to assist in the direction of 48 hours for the use of the boat.


Article source: fishingstory74.blogspot.com

May You Also Like

Leave a Reply

Your email address will not be published. Required fields are marked *