How to Use Straight Shank Hooks

Posted on

How to Use Straight Shank Hooks . Hi all fishing lovers, Today’s post is “How to Use Straight Shank Hooks “. Hopefully this informative article is helpful for you, all fishing lovers.

How to Use Straight Shank Hooks

 how to use Straight Shank Hooks

The Texas rig has become the most used rig for largemouth bass fishing with plastic-type material worms. There are a variety of hooks that fisherman can use inside the vehicle, and the upright shank hook is perhaps the standard of them. it is also doing the longest. Reasons cons of upright shank hooks would the worm tends to fall off. on the other hand, they are further snag-resistant than other hooks.

Instructions

    1

    Thread your bullet sinker on the completed of the fishing line, so that the wide side looks down. the sinker should be heavy enough to help drag the worm at the bottom.

    2

    Bind has a fantastic straight shank hook at the end of the fishing line with a Palomar knot. Hooks, ranging in size from 1/0, 4/0 so you can be the best for fishing with plastic-type worms.

    3

    Set the time of straight-shank hook in the middle of the top of the plastic worm. Drive down quarter-inch, then push each hook point from the worm.

    4

    Push the worm shaft of the hook to the network under a persons vision.

    5

    Turn particular hook 180 degrees the item is facing the plastic worm. Insert the hook point to the worm and hit it by anticipation to stop at the point leads to another area.

    6

    Press at the peak of the worm in the eye of the hook, so that the worm runs straight through the hook.


Article source: fishingstory74.blogspot.com

May You Also Like

Leave a Reply

Your email address will not be published. Required fields are marked *