Methods to Adjust a Transducer

Posted on

Methods to Adjust a Transducer. Hi all of fishing lovers, Today’s post is “Methods to Adjust a Transducer”. Hopefully this article is helpful for you, all fishing lovers.

Methods to Adjust a Transducer

How to modify a Transducer

Fish finders, otherwise known as depth finders, work with a device called a fabulous transducer to rebound sonar waves apart underwater obstacles along with the water bottom. These sonar swells are received back for the transducer, which transmits the feedback to a screen in the motorboat. If the transducer is simply not properly placed — or perhaps adjusted — along side boat’s hull, interference appears at the display screen. This interference is known as noise or bright white noise. The key so that you can removing this noise will be to adjust the transducer’s location on the boat’s hull.

Instructions

    1

    Bring the boat with an area and see the hull. Work with a trailer or a good shallow beach. Choose from a spot within boat that has reached least half that boat length from the the engine, the trolling motor along with the propellers. Mark it area. The cavitation — air bubbles inside water — a result of the propellers creates noise. The engine along with the trolling motor can reduce the transducer sonar surf. Keep the transducer from these areas.

    2

    Clean the mounting portion of any algae, crud or grease. Smear a generous coating with the marine epoxy towards the mounting area so to the back belonging to the transducer.

    3

    Press your transducer onto this glue and store it for four minutes until the application becomes tacky and also the device stays ready. Let the epoxy dry completely based on the glue’s directions.

    4

    Caulk round the edges of the transducer using the silicone caulk that will fortify the transducer’s attachment to your boat hull. Run any cables that or wires depending on fish finder installation directions to display screen with the transducer.


Article source: fishingstory74.blogspot.com

May You Also Like

Leave a Reply

Your email address will not be published. Required fields are marked *