How to Rig Outriggers

Posted on

How to Rig Outriggers . Hi all of fishing lovers, Today’s post is “How to Rig Outriggers “. Hopefully this article is useful for you, all fishing lovers.

How to Rig Outriggers

 How will Rig Outriggers

Outriggers with the multitude of weights, hooks, pulleys and casting leaders attached to the completed spooled fishing line. This type of rig is often used for offshore trolling the ocean and have a boat to make sure you troll several rods without a fisherman who each pole. the plants are usually installed along the hull of the boat into the ground, wish bone, section, or top supports.



    Slide one end of the nylon cord the pad eye. that’s a metal ring proudly situated 12 to 18 inches from your outrigger holder mounted in the edge of the boat hull. Put the completed of the nylon cord to this very metal ring running a button. Pull it free end of the cord guarantee the stability of each node.


    Thread other end of the special nylon cord through the eyes mostly on the boom. The thread can be done the same side of the joist under the entire length. Are not inclined to turn the string in the body of an outrigger.


    Pull the cord on the last view in the stamps. Fold the cable down the capacity of the stamps. Thread the free end in the nylon cord through the center of a cork and give up work on this stopper along the cable until it is positioned parallel in the stamps at a height within the second and, finally, a view of the surface of the dies.


    Attach the upper part of a locked lock swivel to you free end of the nylon cord directly under the cork stopper. Slash excess cable.


    Make perhaps turning lock the coast the top of the release clip on the bottom.


    Confirm the absolute best of a time slot coast turn you down any release clip.


    Thread one end of the nylon cord through the bottom of the 2nd cost twist lock. Secure the cable in the direction of the rotating head with single button. Enter the eye nylon cord in the path that this first piece of cord 2 was anchored to pull the rope taunt and guaranteed eye to the free end path. Tone excess string.

Article source:

Additional Tags for this post:
how to rig outriggers  |  how to rig outriggers for fishing  |  

May You Also Like

Leave a Reply

Your email address will not be published. Required fields are marked *