Make Jig Moulds

Posted on

Make Jig Moulds . Hi all fishing lovers, Today’s post is “Make Jig Moulds “. i hope that this short article is useful for you, all fishing lovers.

Make Jig Moulds

 How to help with making molds Jig make money

Many some anglers think of fishing methods and fishing in familiar waters. Manufactured mold molds so that the fishermen everyday jigs like minnow, bullet and still produce dart jigs. creating custom lures that resemble the food source or just turn on some kind of fish to tasks performed by making your mold fungus. This will allow you to jigs which usually modify your day fishing tactics designs. making molds for sweet or deep molds starts with designing the mold mind.



    fold a joint paper at 50 percent. Draw a sketch belonging to the jig head outside the fold fold. Cut out the outline on the head with a razor or perhaps a pair of scissors. stop leave the cuts in the area of ​​the folded pleat a compact 1/8 inch diameter. Fold the cut as a result some similar patterns that fit on a tab 1/4 inch longer.


    Cut two pieces of 3/4 by 2 inch aluminum inventory 6 inches rather long, with a handsaw. Ironing the cut ends that belong to the aluminum with a flat file in order to do away with any burrs. Place the pieces hand and hand with the 2-inch walls upstairs.


    Align the center of the tab with respect to the mold pattern in view of the seam between the aluminum pieces. Trace the contours of the mold head at any compound of aluminum with a number of marker. Make extra patterns in a style and apply it in the direction of aluminum. A typical 6-inch long jig mold will always four molds.


    Secure a vise with the template sample of half the actual aluminum mold contours experienced. Wear safeness glass before cutting the jig patterns. Use to cut the drill bit with a good grinding cone end to the specific patterns. A mold produced is treated as a reference for that depth of these carvings. Bear in question allows you to explore it accompanied by a file jigs when they are really out of that mold. Repeat with the other half of the aluminum mold and eliminate the vice.


    Mark’s largest market each carving on the edges of the aluminum pieces for a reference. Turn the one side of this form directly transferred to the other line, and which reference characters. Clamp the metal pieces firmly in the vise with the seam between the pieces to the right above.


    Drill a major hole 1/8 inch diameter into the seam at each of the central points. Always make sure the drill bit perpendicular to the top edges of your aluminum. Completely by drilling into the seam to the attachment site of the routine bit leaves the other edge of the pieces. This is essential in order to explain the axis of the fishing hook in the mold.


    Place a centering or 3/4 inch diameter washer in the mold and the hole with ring with one of the many holes in the seam. Draw the circumference of the ring on the top of the mold. Repeat on all holes.


    Use all the cone grinding amount to a major cutting shallow funnel the diameter of the circular contours of each hole. The funnels should be approximately 1/8 inch in size. Remove the fungus belonging to the vise and look up any carvings if desired. Clip the sides into the mold together for each end which will pour lures.

Article source:

May You Also Like

Leave a Reply

Your email address will not be published. Required fields are marked *