To prevent the road to Fish Locater failure

Posted on

To prevent the road to Fish Locater failure . Hello all of fishing lovers, Today’s post is “To prevent the road to Fish Locater failure “. i hope that this short article is useful for you, all fishing lovers.

To prevent the road to Fish Locater failure

fish finders, sometimes referred to as depth finders, talks about the location of schools of fish, underwater hurdles, large single fish and offer lectures on the river bottom. These devices implement sonar waves bounced across the water through a transducer in the boat to collect this data. If the transducer is not really usually placed under the boat in the appropriate position, noise can be displayed on the monitor screen. This interference is known as noise, which is removed by the transfer of the transducer for a better location in the boat.



    Bring the boat for anything from a location where you obtain the bottom belonging to the hull. Find the transducer — a small, black rectangular packaging.


    Remove the transducer or it is close to the algorithm, trolling motor and the motor shaft with propeller. Cavitation — disturbance and air bags — begotten from the aftermath of the screw inhibits information from the transducer. In addition, the engine with trolling motors capability of the device will minimize to receive and emit sonar signals, making noise inside display.


    Tighten all screws to the transducer and pry it away from the hull. Place the transducer in the direction of the largest market of the ship’s hull, in the vicinity of the middle of the boat, so that the way is to form all the motors and props. Drill new mounting holes on the hull of the boat, not to mention screw the transducer position.


    Bring waterproof caulk on the screws, edges and holes in the transducer mounts. Epoxy up to add and practice atart. still to bring back a coat in the caulking to the hull in a watertight closed.

Article source:

May You Also Like

Leave a Reply

Your email address will not be published. Required fields are marked *